| Product Classification |
 Add：
- Room 1801-1803, Jinmao international building, Nanchang Road, Jianxi District, Luoyang, Henan, China
- Tel:(0379)65198226
65198229
- Email:13803790795@139.com
- http://www.lyvenus.net
|
|
|
 |
|
| PZ Vibrate Cone Crusher |
|
Product Information |
 |
The crushing ratio is up to 4-30 and the over crushing is little, reduced the quantity of crushing segment.It is used for pulverizing ultra hard materials, such as FeSi,ferrotitanium, ferromanganese, corundum, spinelle, quartzite, feldspar, carborundum, concrete and so on.And it can start load and parking, and it will not damage the mechanical mechanism of the crusher when there is a foreign body not be broken in operation.Crushing from the most weakness lining surface of the material,the unit electric cost is reduced 40-80%,The average size of the product is not changed when you adjust the clearance of the unloading(such as adjust clearance when the liner is wear out).The overabundance and short feeding quantity will not influnce the load of vibrate cone crusher,because there is no over load about it,so the quantitative feeding apparatus is no use.Crushing the fretted materials need low cost and little pollution.It does not need the weight base so saved 20-30% cost of the basic building .
Using low pressure of thin grease to lubricate, and the system is simple and reliable, easier maintenance;Use the higher movable cone swaying frequency,thus can increase the output and crusher ratio; Use the elasticity system including vibrating mass,eccentric plastid,main vibrating spring, which can realize the vibrating style of sub syntony,vicinity syntony,and farness syntony,and design the different type vibrate cone crusher. But it uses the spherical surface of sliding bearing which can support movable cone for inertial cone crusher,it has decreasing spring rather than main vibrating spring. While the vibrate cone crusher takes advantage of main vibrating spring to support movable cone,in addition to have decreasing vibrating spring, it also has main vibrating spring,and when choosing main vibrating spring hardness and frequency, it can acquire area of sub syntony,vicinity syntony,and farness syntony;There is no spherical surface sliding bearing for inertia cone crusher, which makes the processing very simple,and it has lower price compared with the same standard. It uses the main vibrating spring to support movable cone for vibrate cone crusher, and there is no the spherical surface sliding bearing and sliding bearing of eccentric transmission difficult to process, when it compares with inertia cone crusher and ordinary cone crusher,so it does not need high pressure thin grease equipment,just using ordinary pressure of thin grease,to make the processing less difficult. |
| Next |
|
|
